ORALITE® 5061

Additional information

Brand

Description
3-mil*, high-performance, PMMA film. Available in clear, yellow, red, orange, blue, green, and brown transparent with a
gloss finish. Also available in opaque black with a gloss finish.
Release Liner
4-mil, PET, silicone-coated on one side, reverse treated
Adhesive
Solvent polyacrylate, permanent, transparent
Area of Use
Used as a protective layer on white or printed ORALITE® reflective films intended for long-term outdoor use. Recommended
for use on ORALITE® 5800, 5860 and 5900. Meets or exceeds color and photometric requirements of ASTM D 4956
specifications when used with ORALITE® 7900 Wide Observation Angle Prismatic (coming soon), 5900, or 5800 reflective
films.
Technical Data
Thickness* (without liner and adhesive) 3-mil
Dimensional Stability (FINAT TM14) Adhered to steel, no shrinkage in cross direction;
in length, 0.004”
Temperature resistance Adhered to aluminum, -69°F to 194°F
Adhesive Power (FINAT TM-1, after 24h, average) Adhered to stainless steel: 4.1 lb/in (1 inch) (film tear)
Shelf life** 2 years
Minimum life expectancy*** (based on accepted
application procedures on vertical surfaces)
Up to 12 years
Minimum Application temperature > +50°F
Available lengths
Available widths
150’ (50-yard) and 75’ (10-yard)
24”, 48”
*average ** in original packaging, at 68°F and 50% relative humidity *** standard central European climate
Note:
All ORALITE® products are manufactured within an ISO 9001:2008 controlled manufacturing environment and batch traceability is possible
on the basis of the roll number.
IMPORTANT NOTICE
When using ORALITE® sheeting, please comply with relevant national specifications. ORAFOL recommends obtaining the current
requirements from your local authority and ensure product conformance with such requirements. Please contact ORAFOL for further
information.
All ORALITE® products are subject to careful quality control throughout the manufacturing process and are warranted to be of
merchantable quality and free from manufacturing defects. Published information concerning ORALITE® products is based upon research
which the Company believes to be reliable, although, such information does not constitute a warranty. Because of the variety of uses of
ORALITE® products and the continuing development of new applications, the purchaser should carefully consider the suitability and
performance of the product for each intended use, and the purchaser shall assume all risks regarding such use. All specifications are
subject to change without prior notice.
Surfaces to which the material will be applied must be thoroughly cleaned from dust, grease or any contamination which could affect
the adhesion of the material. Freshly lacquered or painted surfaces should be allowed to dry for at least three weeks and to completely cure
respectively. The compatibility of selected lacquers and paints should be tested by the user, prior to application of the material. The selfadhesive reflective material can only be used for dry application. The low tensile strength of the material can make the removability of the
reflective film more difficult. Please review applicable application information published by ORAFOL.
No warranty is given for purposes other than those listed in the Technical Datasheet or which are not processed according to ORAFOL’s
processing and handling instructions. The durability of the signs will depend on a variety of factors, including but not limited to substrate
selection and preparation, compliance with recommended application guidelines, geographic area, exposure conditions and maintenance of
the product and finished sign. Sign failures caused by the substrate or improper surface preparations are not the responsibility of ORAFOL.
Please refer to the full warranty document available at www.orafolamericas.com for detailed information.
WARNING: This product contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm.
ORALITE® is a trademark of ORAFOL Europe GmbH